Aquasonic Bactonex assists in the prevention of bacterial, fungal and protozoal (Velvet, whitespot, chilodonella, Trichodina & Trichodinella) infections in fresh and salt water fish.   When to Use: When water is changed. When new fish are added and in quarantine aquariums. When fish show signs of listlessness or are off feed.   Directions for Use: Not to be used on fish intended for human consumption. Ensure aquarium water is well aerated during treatment. Do not use activated carbon in the filtration system during treatment as this will remove the product from the aquarium water. If sub-gravel filtration is being used, slow down the flow rates during treatment. This product contains a dye which will stain if spilled.   Dose Rate: Add 10mL per 40 litres of aquarium water. Repeat after 5 days if necessary. DO NOT OVERDOSE. If improvement does not occur, consult your veterinarian or aquarium dealer.TO GIVE NUMBER OF LITRES: To calculate approximate tank capacity multiply length x width x water level height (all in cms) and divide by 1000 for litres.   Active constituents: Each mL of solution contains: 1.66mg Aminacrine hydrochloride and 0.025mg Methylene blue.   Storage: Store below 30C (Room Temperature).   Disposal: Dispose of empty container by wrapping in paper and placing in garbage.   Remember: High standards of aquarium management must be maintained to prevent disease, as fish diseases are often management related. Consult your veterinarian or aquarium dealer for accurate diagnosis and advice.

Read more less

Fungal diseases are common in freshwater fishes and are recognised by white or grey threads on the skin or fins which may thicken until they resemble tufts of cotton wool (pin head size) on the fished body and fins. Unless prompt action is taken fatalities will occur.   Directions for Use: Do not use on fish intended for human consumption. A partial water change (25% capacity) is recommended before commencing treatment. Ensure aquarium water is well aerated and remove activated carbon from filtration system for the duration of treatment. Activated carbon will remove this product from the aquarium water resulting in ineffective. This product contains a dye product which will stain if spilled.   Dose Rate: Add 5ml per 20 litres of aquarium water. For Tetra species, baby fish and scaleless fish (loaches, etc). Use at the reduced rate of 5ml per 40 litres of aquarium water. Repeat after 3 days. TO GIVE NUMBER OF LITRES: To calculate approximate tank capacity multiple length x width x water level height (all in cms) and divide by 1000 or litres.   Disposal: Dispose of empty container by wrapping with paper and putting in garbage.   Storage: Store below 30C (Room Temperature). Replace lid tightly after use.   First Aid Instructions: For advice, contact the Poisons Information Centre (phone Australia 13 11 26; New Zealand 0800 764 766) or a doctor (at once).

Read more less

Fungal diseases are common in freshwater fishes and are recognised by white or grey threads on the skin or fins which may thicken until they resemble tufts of cotton wool (pin head size) on the fished body and fins. Unless prompt action is taken fatalities will occur.   Directions for Use: Do not use on fish intended for human consumption. A partial water change (25% capacity) is recommended before commencing treatment. Ensure aquarium water is well aerated and remove activated carbon from filtration system for the duration of treatment. Activated carbon will remove this product from the aquarium water resulting in ineffective. This product contains a dye product which will stain if spilled.   Dose Rate: Add 5ml per 20 litres of aquarium water. For Tetra species, baby fish and scaleless fish (loaches, etc). Use at the reduced rate of 5ml per 40 litres of aquarium water. Repeat after 3 days. TO GIVE NUMBER OF LITRES: To calculate approximate tank capacity multiple length x width x water level height (all in cms) and divide by 1000 or litres.   Disposal: Dispose of empty container by wrapping with paper and putting in garbage.   Storage: Store below 30C (Room Temperature). Replace lid tightly after use.   First Aid Instructions: For advice, contact the Poisons Information Centre (phone Australia 13 11 26; New Zealand 0800 764 766) or a doctor (at once).

Read more less

Aquasonic Frystarter has been specially formulated to feed newly hatched fry. It contains shrimp, fish, egg, vitamins and minerals, and has a variety of tiny food particles suitable for both livebearer and egglayer fry. When feeding, Frystarter stays in suspension longer, giving the fry a constant supply of food. Filtration should be maintained as an adequate safe guard against the risk of over feeding.    Directions for Use: Feed the newly hatched fry 3-4 drops, 3 times daily dependant on aquarium size and fry numbers. Careful observation will enable you to achieve the correct dosage for your particular species of fish. To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less

Water changes can be very tough on aquarium fish, often resulting in disease or even fatality. Protech has been formulated to effectively assist fish with recovery after a water change, transport or handling. Protech replaces slime coating and makes fish feel well by providing a powerful vitamin mix including: B1, B2, B6, B12, E, and A. This enables the fish to fight off disease and start feeding again quickly. Use during and after transport, after a water change, after any handling of fish or simply as a vitamin supplement. Fungal inhibitors have also been added to help guard against infections.   Directions for Use: 1ml per 20L for general use. For fish in a poor state use treatments as high as 1ml per 5L to assist in faster recovery. For transport use general dose rates. 1ml - approx. 15 drops. To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less

Ammo-gone will neutralise ammonia, chlorine and chloramines, in fresh or salt water. When neutralising ammonia, use an Aquasonic Ammonia Test Kit to determine the level of ammonia present and the increase or decrease the dosage proportionally to neutralise it in one dose. In areas where ammonia or chloramines are a problem in tap water, Ammo-gone is essential. Use each time a new aquarium is installed, when water changes are made or transporting fish. If mixing salt water for marine aquariums, use Ammo-gone. Following the use of of Ammo-gone, use Aquasonic Water Conditioning Salts to create that ideal habitat. For trouble free saltwater, use Aquasonic Ocean Natures Sea Salt. For aquarium use only. Keep out of reach of children.   Directions for Use: To neutralise chlorine or chloramines use 5ml per 20ml of water. To neutralise ammonia, 5ml per 20l of water neutralise 0.75ppm ammonia. Ammo-gone has no effect on marine salts and can be use with invertebrates. Always treat new water before adding to your aquarium.   Note: Ammo-gone may bleach clothing if accidentally spilled. Ammo-gone may cause faulty readings with ammonia test kits that use Nessler's reagents.  

Read more less

Use Power Water Conditioner when starting up an aquarium to remove chlorine and chloramines which can be very harmful to aquarium fish. Power also contains elements that will remove heavy metals from the aquarium. Fungal inhibitors have also been added to help guard against infections.   Directions for Use: 1ml per 10L of water. Use Power when starting up a new aquarium or when adding water for a water change. Premix Power with tap water before adding to aquariums containing fish. After using Power in freshwater aquariums always add Aquasonic Water Conditioning Salts to maintain that natural environment for your fish. In marine aquariums, use Power before the addition of Aquasonic Ocean Nature Sea Salt.

Read more less

Use Power Water Conditioner when starting up an aquarium to remove chlorine and chloramines which can be very harmful to aquarium fish. Power also contains elements that will remove heavy metals from the aquarium. Fungal inhibitors have also been added to help guard against infections.   Directions for Use: 1ml per 10L of water. Use Power when starting up a new aquarium or when adding water for a water change. Premix Power with tap water before adding to aquariums containing fish. After using Power in freshwater aquariums always add Aquasonic Water Conditioning Salts to maintain that natural environment for your fish. In marine aquariums, use Power before the addition of Aquasonic Ocean Nature Sea Salt.

Read more less

Use Power Water Conditioner when starting up an aquarium to remove chlorine and chloramines which can be very harmful to aquarium fish. Power also contains elements that will remove heavy metals from the aquarium. Fungal inhibitors have also been added to help guard against infections.   Directions for Use: 1ml per 10L of water. Use Power when starting up a new aquarium or when adding water for a water change. Premix Power with tap water before adding to aquariums containing fish. After using Power in freshwater aquariums always add Aquasonic Water Conditioning Salts to maintain that natural environment for your fish. In marine aquariums, use Power before the addition of Aquasonic Ocean Nature Sea Salt.

Read more less

Most water supplies such as tap water, are chlorinated. Chlorine can be extremely harmful to aquarium fish. Water Purifier is the most important supplement for the aquarist. Water Purifier will effectively neutralise chlorine and chloramines in tap water immediately, making water safe for aquarium use. Following the use of Aquasonic Water Purifier, use Aquasonic Water Conditioning Salts to create an ideal habitat for fish and aquatic plants. For trouble free saltwater, use Aquasonic Ocean Nature Sea Salt, adding the Water Purifier before mixing salt with water.   Directions for Use: 1ml per 10ml of water.Add to new aquarium water or any water to be added to the aquarium. Pre-mix Water Purifier with tap water before adding to aquariums containing fish. To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less

Aquasonic Vertonex assists in the treatment of white spot (cryptocaryonirritans) when corals and invertebrates are present in marine aquaria. It is safe to use with invertebrates and corals present in the aquarium.

Read more less

Aquasonic Bio-Trace is an essential trace element supplement for marine aquariums. It contains a selection of trace elements found in natural seawater that are easily depleted within the confinements of a marine aquarium. Trace elements are essential for the health, growth and wellbeing of marine fish, corals and invertebrates. Use Aquasonic Bio-Trace weekly for best results.   Directions for Use: 1ml per 50L each week. Use no more than once a week and do not overdose. Treatment may begin when the aquarium is stocked but not before. Regular water changes must still be made. A water change of 25% or more per month is recommended. To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less