All

The Carbonate Hardness (kH) or also referred to as alkalinity of water is the basis for pH values. The stability of pH can be ensured by raising carbonate hardness levels without effect on general hardness.Acids produced in closed circuit aquaria continuously reduce the carbonate hardness levels.   Carbonate Hardness Generator is a special blend of pH buffers that provide a sustained kH level for longer than if using just sodium bicarbonate. Prior raising of carbonate levels will avert drastic falls in pH resultant from these acids, acting to maintain a more stable pH.   Directions for Use: 4g (approx. 1 teaspoon) per 100L of water or 40g per 1000L of water raises carbonate hardness levels by 20ppm. Caution pH levels may rise. It is not recommended to raise carbonate hardness values by more than 20ppm per day.To calculate approximate aquarium capacity: Multiply the length x width x height (in cm) and divide by 1,000 for litres.

Read more less

What is Carbonate Hardness? The extent of carbonate and bicarbonate contained in a sample of water is the Carbonate Hardness value of that sample. Carbonate Hardness affects all aquaria, both salt and fresh. It is called many names, according to the jargon of an industry or country of origin of the test kit, eg CARBONATE HARDNESS = ALKALINITY = kH (German) = ACID BINDING CAPACITY.   Stability of pH The Carbonate Hardness of water is an important measurement, because the level of Carbonate Hardness is the basis for the value of the pH in a given sample of water. A strong Carbonate Hardness reserve in water can mean a very stable pH and the bonus of an alternative supply of carbon dioxide for plants and algae if supply runs short in an aquarium. This applies equally for marine or freshwater aquaria.   Depletion of the Carbonate Hardness Reserve Acids which form as a result of the breakdown of waste products by bacteria (via biological filtration) is the most common way the carbonate hardness reserve is depleted. In aquariums with little or no carbonate hardness the pH is very unstable and can drop very quickly to acid.   Raising Carbonate Harness Aquasonic Carbonate Hardness Generator Powder is recommended for fresh or salt water applications. 5g will raise the Carbonate Hardness of 100L of water by 20ppm.   Directions for Use: The test kit has a dual range, which measures in steps of 10ppm or 20ppm (ppm = parts per million)   To Test in 10ppm: Rinse the clean test tube several times in the water to be tested. Fill the test tube accurately to the 10mL mark. Add 2 drops REAGENT 1 and swirl to mix. A blue colour forms. Now add REAGENT 2 a drop at a time and swirl to mix. Keep count of the drops. As the end point is reached the test tube colour will change to green. Add 1 more drop to complete the change to yellow. Multiply the number of drops by 10 for the reading in ppm.   To Test in 20ppm: Rinse the clean test tube several times in the water to be tested. Fill the test tube accurately to the 5mL mark. Add 1 drop of REAGENT 1 and swirl to mix. A blue colour forms. Add REAGENT 2 a drop at a time and swirl to mix. Keep count of the drops. When the colour changes to yellow the end point is reached. Multiply the number of drops by 20 for a reading in ppm.   Note: Place the test tube on the white background of the colour chart with the light behind you. The colour in the test tube is best viewed with the natural light.

Read more less

The Aquasonic Complete Freshwater 6 in 1 Test Kit is all you need to ensure you have the perfect water conditions in your aquarium.   This 6 in 1 Test Kit includes: Nitrate Test Kit Nitrite Test Kit Ammonia Test Kit Carbonate Harness Test Kit Fresh pH Compele Test Kit (includes pH Down and pH Up) General Hardness Test Kit   Each test kit includes an information card, colour chart, and a clear measuring vial.   Fast, accurate and easy to use!

Read more less

Products For pH Adjustment pH Down (contained in this kit) Use 5g (1 teaspoon) per 70L of water. Wait 12 hours and test pH before redosing. Re-dose at 12 hour intervals until desired pH is reached. pH Up (contained in this kit) Use 5g (1 teaspoon) per 70L of water. Wait 12 hours and test pH before  re-dosing. Re-dose at 12 hour intervals until desired pH is reached.   Directions for Use Rinse a clean test tube and cap several times in water to be tested. Fill to line (12.5ml) with water to be tested. Add 3 drops of Indicator solution Place the test tube on the white background of the colour chart, view vertically (down inside the test tube) with the light behind you. The colour in the test tube is best viewed with natural light. View immediately. Note: Adjust pH slowly.

Read more less

Real plants are an essential factor in providing clearer water and oxygen, they also reduce ammonia and can create a natural vibrant aquarium. Most plants are deficient in iron causing leaves to go yellow. Daily-gro contains chelated iron, formulated to match optimum natural conditions.Daily-gro provides the daily essential nutrients that are lost due to pH effects, oxidisation and filtration. In the natural environment these nutrients are available continually. Daily-gro allows you to re-create this continual supply of essential nutrients, that are normally lost or used up over a 24-hour period, therefore providing a healthy stream of nutrients needed by your aquarium plants every day.   Directions for Use: Add 1ml per 20L of water daily to give a dose rate of 0.50ppm iron. Add 1ml per 40L of water daily to give a dose rate of 0.25ppm iron. To maintain adequate supply of nutrients commence using Daily-Gro nutrient supplement 3 days after initial treatment with Basic-Gro.   For an accurate treament, test the iron levels in your aquarium with an Aquasonic Iron Test Kit to determine iron levels. Recommended iron levels vary betweem 0.25ppm and 1.0ppm. Maintain a minimum Carbonate Hardness level of 50ppm for plant health. Test levels using an Aquasonic Carbonate Hardness Test Kit.   To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less

Real plants are an essential factor in providing clearer water and oxygen, they also reduce ammonia and can create a natural vibrant aquarium. Most plants are deficient in iron causing leaves to go yellow. Daily-gro contains chelated iron, formulated to match optimum natural conditions.Daily-gro provides the daily essential nutrients that are lost due to pH effects, oxidisation and filtration. In the natural environment these nutrients are available continually. Daily-gro allows you to re-create this continual supply of essential nutrients, that are normally lost or used up over a 24-hour period, therefore providing a healthy stream of nutrients needed by your aquarium plants every day.   Directions for Use: Add 1ml per 20L of water daily to give a dose rate of 0.50ppm iron. Add 1ml per 40L of water daily to give a dose rate of 0.25ppm iron. To maintain adequate supply of nutrients commence using Daily-Gro nutrient supplement 3 days after initial treatment with Basic-Gro.   For an accurate treament, test the iron levels in your aquarium with an Aquasonic Iron Test Kit to determine iron levels. Recommended iron levels vary betweem 0.25ppm and 1.0ppm. Maintain a minimum Carbonate Hardness level of 50ppm for plant health. Test levels using an Aquasonic Carbonate Hardness Test Kit.   To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less

Real plants are an essential factor in providing clearer water and oxygen, they also reduce ammonia and can create a natural vibrant aquarium. Most plants are deficient in iron causing leaves to go yellow. Daily-gro contains chelated iron, formulated to match optimum natural conditions.Daily-gro provides the daily essential nutrients that are lost due to pH effects, oxidisation and filtration. In the natural environment these nutrients are available continually. Daily-gro allows you to re-create this continual supply of essential nutrients, that are normally lost or used up over a 24-hour period, therefore providing a healthy stream of nutrients needed by your aquarium plants every day.   Directions for Use: Add 1ml per 20L of water daily to give a dose rate of 0.50ppm iron. Add 1ml per 40L of water daily to give a dose rate of 0.25ppm iron. To maintain adequate supply of nutrients commence using Daily-Gro nutrient supplement 3 days after initial treatment with Basic-Gro.   For an accurate treament, test the iron levels in your aquarium with an Aquasonic Iron Test Kit to determine iron levels. Recommended iron levels vary betweem 0.25ppm and 1.0ppm. Maintain a minimum Carbonate Hardness level of 50ppm for plant health. Test levels using an Aquasonic Carbonate Hardness Test Kit.   To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less

Real plants are an essential factor in providing clearer water and oxygen, they also reduce ammonia and can create a natural vibrant aquarium. Most plants are deficient in iron causing leaves to go yellow. Daily-gro contains chelated iron, formulated to match optimum natural conditions.Daily-gro provides the daily essential nutrients that are lost due to pH effects, oxidisation and filtration. In the natural environment these nutrients are available continually. Daily-gro allows you to re-create this continual supply of essential nutrients, that are normally lost or used up over a 24-hour period, therefore providing a healthy stream of nutrients needed by your aquarium plants every day.   Directions for Use: Add 1ml per 20L of water daily to give a dose rate of 0.50ppm iron. Add 1ml per 40L of water daily to give a dose rate of 0.25ppm iron. To maintain adequate supply of nutrients commence using Daily-Gro nutrient supplement 3 days after initial treatment with Basic-Gro.   For an accurate treament, test the iron levels in your aquarium with an Aquasonic Iron Test Kit to determine iron levels. Recommended iron levels vary betweem 0.25ppm and 1.0ppm. Maintain a minimum Carbonate Hardness level of 50ppm for plant health. Test levels using an Aquasonic Carbonate Hardness Test Kit.   To calculate approximate aquarium capacity: Multiply the length x width x water level height (in cm) and divide by 1,000 for litres.

Read more less

White spot disease is a common fish parasite that can be introduced via new fish, plants, etc. These parasites appear as distinct small white spots (pin head size) on the fish's body and fins. Unless prompt action is taken fatalities will occur.   Directions for Use: Not to be used on fish intended for human consumption. Ensure aquarium water is well aerated for the duration of the treatment. Activated carbon will remove this product from aquarium water resulting in ineffective treatment. Remove from filtration system for duration of treatment. This product contains a dye product which will stain if spilled.   Dosage rates: Use at the rate of 5mL per 20 litres of aquarium water. Harmful to corals. Do not overdose. Repeat treatment after 3 days if necessary. For tetra species, baby fish and scaleless fish (loaches etc.), use at a reduced rate of 5mL per 40 litres of aquarium water.   Storage: Store below 30C (Room Temperature). Replace lid tightly after use.   Disposal: Dispose of empty container by wrapping with paper and putting in garbage.   Safety Instructions: Will irritate the eyes. May irritate the skin. Avoid contact with eyes and skin. If product on skin, wash immediately with soap and water. If product in eyes, wash it out immediately with water. Wash hands after use.   First Aid Instructions: If poisoning occurs, contact a doctor or Poisons Information Centre. Phone Australia (13 1126; New Zealand 0800 764 766). If swallowed, do not induce vomiting. Give a glass of water. If skin contact occurs, remove contaminated clothing and wash skin thoroughly. Remove from contaminated area. Apply artificial respiration if not breathing. If in eyes, holde yes open. flood with water for at least 15minutes and see a doctor. WARNING - Avoid contact with eyes. Avoid contact with skin. Avoid breathing vapor.

Read more less

White spot disease is a common fish parasite that can be introduced via new fish, plants, etc. These parasites appear as distinct small white spots (pin head size) on the fish's body and fins. Unless prompt action is taken fatalities will occur.   Directions for Use: Not to be used on fish intended for human consumption. Ensure aquarium water is well aerated for the duration of the treatment. Activated carbon will remove this product from aquarium water resulting in ineffective treatment. Remove from filtration system for duration of treatment. This product contains a dye product which will stain if spilled.   Dosage rates: Use at the rate of 5mL per 20 litres of aquarium water. Harmful to corals. Do not overdose. Repeat treatment after 3 days if necessary. For tetra species, baby fish and scaleless fish (loaches etc.), use at a reduced rate of 5mL per 40 litres of aquarium water.   Storage: Store below 30C (Room Temperature). Replace lid tightly after use.   Disposal: Dispose of empty container by wrapping with paper and putting in garbage.   Safety Instructions: Will irritate the eyes. May irritate the skin. Avoid contact with eyes and skin. If product on skin, wash immediately with soap and water. If product in eyes, wash it out immediately with water. Wash hands after use.   First Aid Instructions: If poisoning occurs, contact a doctor or Poisons Information Centre. Phone Australia (13 1126; New Zealand 0800 764 766). If swallowed, do not induce vomiting. Give a glass of water. If skin contact occurs, remove contaminated clothing and wash skin thoroughly. Remove from contaminated area. Apply artificial respiration if not breathing. If in eyes, holde yes open. flood with water for at least 15minutes and see a doctor. WARNING - Avoid contact with eyes. Avoid contact with skin. Avoid breathing vapor.

Read more less